Advertisement
HYDRAULIC CONTROLS -WHEEL (cont.)
• GEAR (HIGH/ LOW) (Same on Remote)
This switch is on the side of the control
panel and on the remote. (Note: to control
the gear selection functionality with the
wireless remote, the gear switch on the
machine control panel must be in the
HIGH position.) The switch controls the
drive motors and determines how fast the
machine travels. High gear is for moving the
machine from one place to another very
quickly. (Note: the cutter wheel will not
operate in High gear.) Low gear is used for
precision when positioning the cutter wheel
close to the stump or when more power is
needed for climbing. For further control of
the ground speed when in low gear, use the
ground speed adjustment valve (see below).
• SWING SPEED ADJUSTMENT VALVE
Located on the side of the control panel unit,
this valve controls the swing speed of the
cutter head. Adjust swing speed for smooth
operation. Turn the valve control knob
counter-clockwise to slow the swing speed
at high engine speeds. Close the valve by
turning clockwise to allow the cutter wheel
to move side to side at low engine speed.
•
GROUND SPEED ADJUSTMENT VALVE
Located on the side of the control panel unit,
this valve controls ground (travel) speed
when in low gear. Turn the valve clockwise
to increase speed and counter-clockwise to
slow speed.
SP6016
MACHINE CONTROLS
SWING SPEED
ADJUSTMENT
GROUND SPEED
ADJUSTMENT
GEAR
HIGH/LO
W
12
Advertisement
