Advertisement
HYDRAULIC CONTROLS (cont.)
TRACK MACHINE:
• RIGHT TRACK (FWD/REV)
(Shown as R. TRACK-FORWARD /
REVERSE on Remote.) This switch
operates only the right track drive motor.
• LEFT TRACK (FWD/REV)
(Shown as L. TRACK-FORWARD /
REVERSE on Remote.) This switch
operates only the left track drive motor.
➢
Use both controls in the same direction
(
FWD/FWD or REV/REV
forward or reverse. The radio transmitter also
has a single switch (BOTH TRACKS) that will
move both tracks at the same time in the forward
or reverse directions.
➢
Use controls opposite (
of each other to turn machine either right or left.
When rotating the machine, try not to leave one
track stationary while rotating the other one
around as this could cause the machine to jump a
track. If it is desired to spin the machine,
counter-rotate the tracks.
• CUTTER WHEEL (DOWN/UP)
(Shown as CUTTER HEAD-DOWN/UP on
Remote.)
This switch operates the cutter head lift
function, which lowers and raises the cutter
head.
• BOOM TRAVEL (LEFT/RIGHT)
(Shown as CUTTER HEAD-LEFT/RIGHT
on Remote.)
This switch operates the cutter head swing
function, which swings the boom back and
forth in a left-right-left-right-left... motion.
SP6016
) to move machine
)
REV/FWD or FWD/REV
MACHINE CONTROLS
13
Advertisement
