Advertisement
PROGRAMMING OMNEX WIRELESS REMOTE
If there is a problem with the receiver or the transmitter and either must be replaced, you will
need to program the new unit to communicate with the existing unit. Or if you have more than
one transmitter for this machine, it will need to be programmed to communicate with the existing
receiver. (Refer to the provided radio control manual for detailed programming instructions.)
• To access the receiver, remove the cover
from the machine control box.
• Remove the radio receiver unit by removing
the screws in the junction box lid. Then
remove the circuit panel by unlatching the
plastic tabs on either side of the receiver
housing. The receiver panel will now slide
out of the cap. Note: you may need to
unplug the wiring harness before removing
the circuit panel. Be sure to plug harness
back in before attempting to program
remote.
• Follow the instructions in the radio control
manual to download the ID Code.
• Push the receiver panel back up into the cap
until the tabs snap back into place.
• Replace junction box lid and tighten screws.
• Replace the machine control box cover.
CAUTION
Do Not Run Machine Without All Guards and
Covers in Place and Secure.
Do Not Weld on the Machine Without First
Disconnecting the Battery and Wireless
Receiver Wire Harness.
SP6016
MACHINE CONTROLS
16
Advertisement
