Advertisement
More accidents occur while performing maintenance than any other time! Use extra caution!!
DO NOT PERFORM MAINTENANCE OF ANY KIND ON THIS MACHINE UNLESS:
The engine is turned off.
The ignition key has been removed.
The positive battery cable has been disconnected.
The clutch is disengaged.
All machine parts have come to a complete stop.
All machine parts have had sufficient time to cool down.
No operator is in position at the controls to accidentally start machine.
At least 2 people are at the site where maintenance is performed.
• PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
• ALWAYS CLEAN TIP OF GREASE GUN FITTING AND GREASE FITTING ON
MACHINE BEFORE ATTACHING HOSE TO PREVENT DIRT FROM BEING
FORCED INTO MACHINE PARTS.
• The most service you should have to do for
the bearing supported stub shaft is to grease
it properly. There is a grease fitting on the end
of the stub shaft to grease the splines in the
coupling. Follow the instructions in the
Machine Maintenance section for frequency
and application of grease. Also see the
Lubrication Chart.
REPLACE STUB SHAFT
• Remove the V-belt following the
instructions in the Servicing Belt Section of
the manual.
• Remove the engine belt keepers instead of
just loosening the bolts and lay aside to put
on new stub shaft plate assembly.
SP6016
!
DANGER
SERVICING STUB SHAFT
51
Advertisement
