Advertisement
OPTIONAL:
Razor Cutter Wheel
• If the machine is supplied with the
optional Razor cutter wheel, there are 36
teeth to a complete set. There are 12
outer Short Plow Bolt with Long Head
Bits and 24 side Plow Bolt Bits.
CAUTION
Do not operate machine without a full set
of teeth. Operating machine without a
full set of teeth can cause excessive
vibration and premature bearing failure.
• A locking pin is provided to hold cutter
wheel in position during tooth removal
and re-installation. The locking pin will
only lock in the deep slots of the outer
teeth. Line the slot up with the locking
pin slot and insert the pin to lock
position. The pin will need to be
removed and reinserted as wheel is
rotated to change remaining teeth.
CAUTION
Never place your hand on the cutter wheel
to hold it in place while changing teeth.
Be sure to remove the pin before operating
the stump cutter.
• The teeth do not require a setting gauge.
The only requirement is to be installed in
the proper direction and tightened to the
proper torque as discussed in the next
section.
NOTE: When replacing a cutter wheel
tooth, replace the tooth and nut as a set
and use anti-seize on the threads.
SP6016
SERVICING CUTTER WHEEL
39
Advertisement
