Advertisement
More accidents occur while performing maintenance than any other time! Use extra caution!!
DO NOT PERFORM MAINTENANCE OF ANY KIND ON THIS MACHINE UNLESS:
The engine is turned off.
The ignition key has been removed.
The positive battery cable has been disconnected.
The cutter wheel is disengaged.
All machine parts have come to a complete stop.
All machine parts have had sufficient time to cool down.
No operator is in position at the controls to accidentally start machine.
At least 2 people are at the site where maintenance is performed.
• PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
• Check engine oil at dipstick (Daily). Take
reading with engine sitting level. Add
recommended oil and change oil as required.
(See engine owner's manual for details.)
• Check hydraulic oil with engine off and cool
(Daily). A site glass is provided for easy
viewing. Oil should be visible in the site
glass before operating. Replenish, as
necessary. Do not fill the tank more than 3/4
the way up the site glass to allow space at
the top for expansion as oil gets warm.
Remember to replace and tighten cap.
Note: This machine is filled with Citgo
AW46 hydraulic oil at the time of
manufacture. Refill with the same or
equivalent oil.
• Inspect hydraulic hoses and fittings for
leaks, tightness, wear, or damage (Daily).
Repair or replace as needed. (See hydraulic
servicing section for details.)
!
WARNING
Hydraulic oil is under pressure. Spraying fluid
from a leak can burn or penetrate the skin and
cause serious injury. If fluid penetrates the skin,
immediately seek medical attention to have it
surgically removed! Always wear eye protection!
SP6016
!
DANGER
MACHINE MAINTENANCE
27
Advertisement
