Advertisement
SP6016
•
DO NOT OPERATE THE ENGINE AT AN ANGLE
GREATER THAN 25° OR SEVERE ENGINE DAMAGE
WILL OCCUR. PROPER ENGINE OIL LEVEL MUST BE
MAINTAINED TO ACHIEVE MAXIMUM ANGLE OF
OPERATION OF 25°. (See Engine Owner's Manual for proper
oil level.)
•
Never allow spectators to stand and watch machine in operation
without proper hearing and eye protection and standing at a safe
distance. Loud noise and flying debris may cause severe injury.
•
DO NOT
operate around water, gas, power or phone lines.
Check with property owner or call utilities if not sure.
•
Avoid fences and clear away other objects (i.e. sticks, stones,
metal, etc.).
•
Be aware of the possibility of foreign objects imbedded in or
buried around the stump. Do not cut crosswise of roots above
ground to prevent roots being thrown.
•
If unusual vibration occurs, stop engine immediately and correct
problem before continuing operation.
•
Keep all guards in place and properly secured during operation.
•
Keep all safety devices working properly and all other machine
parts in good working condition.
•
Never leave the controls unattended while in operation. Be sure
machine is not capable of operation when left unattended.
•
Stop engine and remove key when repairing or adjusting machine
or drive belts.
•
Keep engine in good condition, service as instructed in engine
manual.
•
DO NOT
touch engine while running or hot (serious burns may
result).
•
Allow all machine parts to cool completely before servicing or
adjusting. Hot machine parts can cause severe burns.
•
DO NOT
run the machine without a complete number of teeth in
the cutter wheel tightened to the correct torque.
•
DO NOT
place machine in free wheel without first placing
tongue stake in the ground.
•
Park machine on level surfaces only. Lower cutter head to the
ground and use wheel chocks to prevent unattended movement.
•
DO NOT
operate stump cutter in dark, dim lit, or concealed
areas.
•
Keep machine clean and clear of debris to eliminate fire hazard.
It is especially important to clean any oil or fuel spills to prevent
the danger of fire.
•
Keep cutter wheel skirt guards in good condition to help control
chips during grinding.
•
Keep safety and instructional decals clean and replace any that
are damaged, difficult to read, or missing. Decals may be
purchased from J.P. Carlton or an authorized dealer.
SAFETY PRECAUTIONS
8
Advertisement
