Advertisement
More accidents occur while performing maintenance than any other time! Use extra caution!!
DO NOT PERFORM MAINTENANCE OF ANY KIND ON THIS MACHINE UNLESS:
The engine is turned off.
The ignition key has been removed.
The positive battery cable has been disconnected.
The cutter wheel is disengaged.
All machine parts have come to a complete stop.
All machine parts have had sufficient time to cool down.
No operator is in position at the controls to accidentally start machine.
At least 2 people are at the site where maintenance is performed.
• PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
Replacing Engine Belt
• Remove engine belt guard cover, by
removing the bolts that hold it on.
• To loosen the belt, use the engagement
handle to slide the engine as far as it will
go toward the cutter wheel.
• Once the belt is loose, around each
sheave there are belt keepers, loosen and
adjust to allow removal of belt. Install
new belt then readjust and tighten belt
keepers.
SP6016
!
DANGER
SERVICING BELTS
45
Advertisement
