Advertisement
DAILY CHECKS SHOULD BE PERFORMED BEFORE STARTING ENGINE FOR THE
DAY. DO NOT INSERT KEY INTO ENGINE UNTIL ALL CHECKS HAVE BEEN
COMPLETED.
• Check engine oil at dipstick. Engine
must be level. Boom in raised position
will not affect the engine position;
machine must be on level ground. Add
recommended oil, as required. (See
Engine Owner's Manual)
• Inspect dry air filters. REPLACE, if
necessary, WITH FACTORY AIR
FILTER ONLY. Do not blow out or tap
on ground. Replace inner safety filter
when dirty or when the outer air filter
has been changed 3 times. Do not blow
out the inner safety filter or tap on
ground. (See Engine Assembly section
for part numbers.)
• Check fuel filter for debris or water.
Replenish fuel tank with fresh fuel.
• Check condition and tightness of drive
belts. (See Maintenance Section) New
belts will stretch and become loose as
machine runs. Check belt tension often
when belts are new.
• Check for any loose, broken, or missing
teeth and pockets.
• Inspect bolts, hydraulic fittings, wiring
harnesses, hoses, and equipment for
tightness, wear, or leakage. Replace if
necessary.
• Check hydraulic oil level. A sight glass
is located on the tank. Add oil if
required. In hot weather do not fill
window full, the oil will expand and spill
out.
• Grease boom and jackshaft bearings
daily; apply only 2 to 4 shots of grease.
Do not over grease.
• Cutter wheel bearings must be purged
with grease daily. Purge until clean
grease is seen.
SP6016
DAILY CHECKLIST
MAIN FILTER
SAFETY FILTER
BOOM & JACKSHAFT BEARINGS
CUTTER WHEEL BEARINGS
10
Advertisement
