Advertisement
ENGINE CONTROLS
*Refer to the engine manufacturer's manual for controls, operation, and service.
If the machine is equipped with the optional wireless remote system, it will have an On/Off
toggle switch and engine ignition key switch for startup and shutdown of the engine. The On/Off
toggle switch is located on the machine control box and must be switched to the On position
before engine will start.
• On/Off Switch
This is a three-position switch; Off, Remote On or
Machine On. To operate the machine with the
remote control, first place the switch in the Remote
On position then turn the engine ignition key switch
to the On position. Follow the Remote Operations
procedure to complete startup. To operate using
machine control panel, first place the switch in the
Machine On position then turn the engine ignition
key switch to the on position. To shut off the
engine, return the On/Off switch to the Off position.
(Refer to Machine Operations Section of manual for
startup and shutdown procedures)
• Ignition Switch
Turn the ignition key switch clockwise one stop
(On position) to turn the electrical system on. The
key should remain in the on position while the
engine is running. Turn the key fully clockwise
(Start position) this will start the engine. To shut
off the engine, return the key to the off position.
(Refer to the engine manufacturer's manual for
specific engine controls and operation.)
CUTTER WHEEL ENGAGEMENT LEVER
Engaging or Disengaging Cutter Wheel at High
Engine Speed Can Cause Personal Injury and
Machine Damage. Always Disengage Before
Turning Machine On/Off.
➢ Before engaging or disengaging the cutter
wheel, make sure the engine is at an idle
speed! To engage the cutter wheel, lift the slide
lock lever and pull the engagement handle
towards the engine. To disengage the cutter
wheel, push the handle away from the engine.
SP6016
!
DANGER
MACHINE CONTROLS
IGNITION KEY SWITCH
SLIDE LOCK
18
Advertisement
