Advertisement
HYDRAULIC CONTROLS
Your wheel or track machine has a series of hydraulic controls located on the machine
control panel and radio transmitter, which are clearly marked for use. To operate, push
levers/toggle switches in the direction of the command you want to perform. See illustrations
(right) and details below.
WHEEL MACHINE:
• STEERING TRAVEL (RIGHT / LEFT)
(Shown as STEER on Remote.) This switch
operates the front tires directing them right or
left.
• UNIT TRAVEL (FWD / REV)
(Shown as TRAVEL on Remote.) This switch
operates the drive motors.
• CUTTER WHEEL (DOWN / UP)
(Shown as CUTTER HEAD-DOWN/UP on
Remote.) Use this switch to raise and lower
the cutter wheel.
• BLADE (UP/DOWN)
(Note: may be labeled as TONGUE on
Remote). This switch raises and lowers the
push blade at the front of the machine.
• BOOM TRAVEL (LEFT/ RIGHT)
(Shown as CUTTER HEAD-LEFT/RIGHT on
Remote.) This switch operates the cutter head
swing function, which swings the boom back
and forth in a left-right-left-right-left...
motion.
SP6016
MACHINE CONTROLS
B
L
A
D
E
STEER
STEER
B
L
A
D
E
11
Advertisement
