Advertisement
HYDRAULIC CONTROLS -TRACK (cont.)
• FLOW (HIGH/ LOW) (Only on Remote)
Flow control affects how fast the machine
travels. High flow is for moving the machine
from one place to another very quickly. Low
flow is used for more precision in tight
places or when positioning the cutter wheel
close to the stump. For further control of the
ground speed in low flow, use the Ground
Speed Adjustment Valve. (Note: The
machine must be in low flow before
operating the cutter wheel.)
REMOTE CONTROLS
Note: we use multiple remote manufacturers.
* Refer to the remote manufacturer's manual for specific controls, operation, and service.
• Emergency Stop Button (E-STOP)
On a HATOX remote: Twist E-stop to
activate remote.
On an OMNEX remote: Press button then
toggle any switch on the remote to activate
transmitter. Within 10 seconds, twist E-Stop
button clockwise and release to turn on the
transmitter for use. To turn off the
transmitter and immediately shut off the
engine, Press E-Stop button.
• Toggle Switches
Push toggle switches in the direction of the
command you want to perform. See
previous section under Hydraulic Controls
for details on function of each switch.
• Low Battery/Fault Light
Light will indicate when battery is low or if
a fault exists. (Refer to manufacturer manual
for troubleshooting)
• Active Light
Light will flash on power up and during
normal operation.
SP6016
MACHINE CONTROLS
15
Advertisement
