Further Transport Without Wooden Pallets - Siemens NXAIR Installation Instructions Manual

6.12 Further transport without wooden pallets

There are several methods that can be used in handling the further transport without wooden pallet. Panel
transportation on the site is under the responsibility of the customer. The handling method used will be
determined by conditions and available equipment at the installation site. The hydraulic lifters, roller pads or
other transportation devices can be used for the transportation.
Hydraulic lifters, roller pads or other transportation devices are not an integral part of the scope of supply of
the switchgear.
If the transport units cannot be directly lifted from the wooden pallets onto their place of installation:
Roller pads:
Lower the transport unit onto boards placed on roller pads (reinforced rollers), i.e. one board
placed on two roller pads. Distribute the roller pads so as to support the outer edges of the
transport unit.
Lift one side, then the other side of the transport unit and slowly lower it on the place of
installation.
110-0084.9 / 15
DANGER
Transport units falling down or over
If incorrectly transported, the transport units may fall down and cause injury.
Please ensure that the lifting and transport gear used meets the
requirements as regards construction and load-bearing capacity.
Observe the center of gravity of the transport units.
Secure the transport units against tipping.
Move the transport units slowly and carefully.
Put on personal protective equipment.
NXAIR /
Unloading and erection
≤
40 kA 43