Mounting The Craning Angles - Siemens NXAIR Installation Instructions Manual

Unloading and erection
Incorrect application of lifting tool
Not permissible application of a lifting tool:
Fig. 27: Incorrect application of lifting tool
6.9

Mounting the craning angles

The craning angles are delivered in a set. The set comprises the craning angles and the necessary bolted
joints. Depending on the panel version, 3 or 4 craning angles must be mounted on the panel.
34
NOTICE
Mounting the craning angles
Depending on the panel version, different craning angles of the set are to be
mounted.
Craning angle at the side of the panel: 3 bolted joints M8x20.
Craning angle at the rear of the panel:
2 bolted joints M8x20.
Observe the information drawings NXAIR, order number 110-2300.9.
INFORMATION
The craning angles allow the use of crane rods as well as the attachment of crane
hooks to transport the panels without wooden pallet.
NXAIR /
Fig. 28: Incorrect application of lifting tool
≤
40 kA 110-0084.9 / 15