Siemens NXAIR Installation Instructions Manual page 218

Installation report
NOTICE
Too high test voltage
Excessive test voltages may result in damage to equipment.
•
Do not perform dielectric test at test voltages exceeding the ratings of the tested equipment.
13. High-voltage tests acc. to IEC 62271 Part 200 Clause 7.105
High-voltage test performed and reported in attached document?
Annex:
Installation report to be submitted after completion via e-mail or normal mail to:
218
DANGER
Hazardous voltage
After high-voltage test:
Switch off high-voltage test equipment and remove high-voltage test
equipment carefully.
NOTICE
After successful high-voltage testing:
Reset capacitive voltage indicators.
Remove short circuits from current transformers.
Put voltage transformers and surge arresters/limiters back into operation.
E-mail: support.energy@siemens.com
Siemens AG
Global Customer Care AIS-MV
Postal EM MS GCC AIS-MV
Carl-Benz-Straße 22
address:
60386 Frankfurt am Main
Germany
Fax: +49 69 4008-2623
NXAIR /
≤
40 kA
yes no n/a
110-0084.9 / 15