Transport And Storage; Scope Of Supply; Transport - Siemens FLENDER H SH Series Assembly And Operating Instructions Manual

4.

Transport and storage

Observe the instructions in section 3, "Safety instructions"!
4.1

Scope of supply

The products supplied are listed in the despatch papers. Check immediately on receipt to ensure that all
the products listed have actually been delivered. Parts damaged and/or missing parts must be reported
to Siemens in writing immediately.
If there is any visible damage, the gear unit must not be put into operation.
4.2

Transport

When transporting Siemens products, use only lifting and handling equipment of
sufficient load­bearing capacity!
Observe the notes regarding load distribution on the packing.
The gear unit is delivered in the fully assembled condition. Additional items may be delivered separately
packaged.
Different forms of packaging may be used, depending on the size of the unit and method of transport.
Unless otherwise agreed, the packaging complies with the HPE Packaging Guidelines.
The symbols marked on the packing must be observed at all times. These have the following meanings:
Top
Fig. 3: Transport symbols
Transport of the gear unit must be carried out so as to avoid personal damage and
damage to the gear unit.
If, for example, the free shaft ends are knocked, this may damage the gear unit.
The gear units must be transported with suitable equipment only.
During transport the gear unit should be left without oil filling and on the transport packing.
Use only the eyes provided to attach lifting equipment to the unit.
Handling of the gear unit by attaching it to the piping is not permitted.
The pipework must not be damaged.
Do not use the front threads at the shaft ends to attach slinging and lifting gear for
transport.
Slinging and lifting gear must be adequate for the weight of the gear unit.
Fragile Keep dry
BA 5030 en 02/2013
Keep cool Centre of
gravity
21 / 96
Use no hand Attach here
hook