Command Configuration; Move 1 Command Configuration - gefran POS-MINI SIEIDrive Instruction Manual

3.7. COMMAND CONFIGURATION

This page allows to configure some commands.
1
2
3
1. It configures the Move 1 command.
2. It configures the Move 2 command.
3. It configures the Move N command.
4. It loads the parameters contained in a PC file onto the DGFC.
5. It saves the DGFC parameters on a PC file.

3.7.1. Move 1 Command Configuration

5
6
1. Value to be reached.
2. Speed of the MOVE 1 command.
3. Acceleration of the MOVE 1 command.
4. Jerk of the Move 1 command.
5. It selects the source of the Move 1 command.
6. It selects the source of Target Pos 1.
7. Setting of the reached value threshold.
Flag:
a- Pad 3. Value source Pad when the value is selected by the analog input.
b- Target Pos 1. Value obtained after the scaling procedure if the value source is set by the analog input.
One-axis positioner
—————— Instruction manual ——————
1 2 3
4
5
4
7
a
b
19