The configurator is a tool allowing to configure and run the position control.
3.1. MAIN PAGE
The commands available on this page are the following:
•
Command
it enables the manual command page.
•
Set 01-12
it enables the page aimed at setting the position Sets from 01 to 12
•
Set 13-24
it enables the page aimed at setting the position Sets from 13 to 24
•
Set 25-36
it enables the page aimed at setting the position Sets from 25 to 36
•
Set 37-48
it enables the page aimed at setting the position Sets from 37 to 48
•
Set 49-60
it enables the page aimed at setting the position Sets from 49 to 60
•
Set 61-64
it enables the page aimed at setting the position Sets from 61 to 64
•
Set Area
it enables the page aimed at setting the area Sets
•
Dig. Input configuration
•
Dig.Output configuration
•
Encoder configuration
•
Absolute Encoder Configur.
•
Axis configuration
•
Command Configuration
•
About Application ...
•
Idle
•
Ready
•
Run
•
ResetAlarm
•
GetStatus
•
Refresh
•
Download
•
Upload
•
Save
•
Exit
One-axis positioner
3. CONFIGURATOR
it enables the page for the digital input configuration
it enables the page for the digital output configuration
it enables the page for the encoder configuration
it enables the page for the absolute encoder configuration
it enables the page for the positioner configuration
it enables the page for the command and analog input configuration
it enables the page containing the information about the application
version
it forces the DGFC card to the Idle state
it forces the DGFC card to the Ready state
it forces the DGFC card to the Run state
it resets possible still present DGFC alarms
it shows the DGFC present state
it refreshes the present page
it loads the parameters contained in a PC file onto the DGFC
it saves the DGFC parameters on a PC file
it saves the DGFC parameters into the retentive memory of the DGFC
it closes the present page
—————— Instruction manual ——————
13