Taping Heads Completion; Outboard Tape Roll Holder; Preliminary Electric Inspection; Main Power Machine Connection And Inspection - 3M -Matic 7000a-I Instructions And Parts List

7. Installation
7.7 Completion of Taping Heads
See Manual 2 or 3 for Complete
Instructions:
1. Place the Upper Taping Head in
2. Use Figure 7-8 and tape threading
3. Attach the threading needle to
4. Continue pulling the threading
5. Pull the threading needle down
6. Cut away any excess tape and re-
Important – Do not cut against the

7.8 Outboard Tape Roll Holder

If you intend to use the outboard
tape roll holder, proceed as follows:
1. Remove the lower taping head
2. Remove the tape drum bracket
3. Install alternative wrap roller and
4. Install and secure tape drum
3M-Matic 7000a-I / 7000a3-I Pro - Type 11700
™
Page 21
44-0009-2164-1 / ECO# 0078045
(continued)
a convenient working position.
label. Position the tape supply roll
so the adhesive side of tape is
facing the front of the taping head
as it is pulled from the supply roll.
the end of the roll. Guide the
threading needle around the
wrap roller (Position 1) then
back around the one-way
tension roller (Position 2).
needle down and guide it
between the two (2) rollers on
the apply arm (Position 3).
until the tape travels between the
apply plate and the ears of the
apply arm (Position 4) until it
extends past the applying roller.
When properly threaded the
adhesive side of the tape should
be facing the knurled rollers at
position 2 and also position 3.
peat steps for Lower Taping Head.
apply roller - roller
damage could occur.
from the machine.
assembly, stud spacer, and fast-
eners from the lower taping head.
bracket on the head in place of
tape bracket. Replace lower
head into machine.
bracket assembly on the entry
end of the lower frame
(as shown in Figure 7-9).
Source Document for all related Manuals/Translations
#2
#3
Figure 7-8
Figure 7-9

7.9 Preliminary Electric Inspection

Before connecting the machine to the mains
please carry out the following operations:
7.9.1 Make sure that the socket is provided with
an earth protection circuit and that both the
mains voltage and the frequency match
the specifications on the name plate.
7.9.2 Check that connection of machine to the
mains meets safety regulations in your country.
7.9.3 The machine is fitted with a main switch and a
circuit breaker. The user should check that the
electrical settings of machine are compatible
with all the components of the mains system.
7.10 Machine Connection to the Mains
This machine may be received without an
electrical plug. Select a plug suitable for your
existing electrical service and compliant with
local electrial codes. Connect the Line, Neutral,
and Ground (Protective Earth) wires of the
machine to the appropriate terminals of the
plug following plug manufacturers instructions.
(400V, 3Ph motors are in a delta configuration).
Important: All connections must be made by a
quailfied electrical service technician.
Original Instruction
One Way
Tension
Roller
#1
Tension
Wrap
Roller
Knurled
Roller
Wrap
Roller
Applying
Roller
Threading
#4 Needle
International - ENG
February 2021