3M -Matic 7000a-I Instructions And Parts List page 46

13. Maintenance and Repairs
Refer to Figure 13-5 and 13-6 and
adjust belt tension as follows:
1. Remove and retain center plate/
front cover and four (4) screws.
2. Loosen, but do not remove lock
nut with an open end wrench.
3. Reset the tension on the drive
belts as needed. Adjust the M8
tension screws in (clockwise) to
increase tension or out (counter-
clockwise) to decrease tension.
Tighten lock nut to secure
tension setting.
4. Replace center plate/front
cover and secure with
original screws.
3M-Matic 7000a-I / 7000a3-I Pro - Type 11700
™
Page 34
44-0009-2164-1 / ECO# 0078045
(continued)
Drive
Belts
Lock
Nut
Note:
Drive
Belts
Lock
Nut
Original Instruction
Source Document for all related Manuals/Translations
Center
Plate
Flat Hd Screw
(4)
Socket Hd
Adjustment
Infeed End
Adjustment Screw is accessed
through rear hole in Machine Frame
Figure 13-5 Lower Drive
Front
Pan Hd Screw
Cover
(4)
Hex Hd
Infeed End
Tension Screw
Figure 13-6 Upper Drive
Tension
Screw
Hex
Wrench
Box
Wrench
International - ENG
February 2021