Safety Measures (See Section 3); Tools And Spare Parts Supplied With Machine; Maintenance Operations - Recommended Inspections/Frequency; Inspections Performed Before/After Every Maintenance Operation - 3M -Matic 7000a-I Instructions And Parts List

13. Maintenance and Repairs
13.1 Safety Measures (see section 3)
13.3 Recommended Frequency of
Operation
Inspection safety features
Cleaning of machine
Cleaning of cutter blade
Oiling of felt pad
Lubrication
Blade replacement
Drive belt replacement
13.4 Inspections to be Performed
13.5 Check Efficiency of Safety Features
13.6 Cleaning of Machine
3M-Matic 7000a-I / 7000a3-I Pro - Type 11700
™
Page 31
44-0009-2164-1 / ECO# 0078045
Turn off all electrical and pneumatic sources
of power before attempting any mainte-
nance or repairs on this equipment.
Lockout and Tagout each power source
in accordance with local regulations or
company policy.
Inspection and Maintenance Operations
Before and after every
Maintenance Operation
Before every maintenance operation,
Turn the main switch OFF (O) and
disconnect. During the maintenance
operation, only properly trained and
qualified personnel must work on
the machine. At the end of every
maintenance operation check the
safety devices.
1. Blade guard assembly upper
taping head.
2. Blade guard assembly lower
taping head.
3. Latching Emergency stop button
with mechanical lock (interrupt
supply of electrical power).
4. Turn main switch STOP/OFF (O)
5. Safety guards top drive belts.
Qualification 1
A weekly cleaning with dry rags or
diluted detergents is necessary.
Cardboard boxes produce a signi-
ficant quantity of dust and paper
chips when processed or handled in
case sealing equipment. If this dust is
allowed to build up on components,
it can cause component wear and
over-heating of drive motors.
Source Document for all related Manuals/Translations
13.2 Tools and Spare Parts Supplied
Frequency Qualification
daily
weekly
weekly
weekly
monthly
when worn
when worn
13.7 Cleaning of Cutter Blade
• To reduce the risk associated with
mechanical and electrical hazards:
− Read, understand, and follow all safety
and operating instructions before
operating or servicing the case sealer.
− Allow only properly trained and qualified
personnel to operate and service this
equipment.
• To reduce the risk associated with
pinches, entanglement and hazardous
voltage:
− Turn electrical supply off and disconnect
before performing any adjustments,
maintenance or servicing the machine or
taping heads.
Original Instruction
with the Machine
No tools are provided with this equipment.
Recommended Tools:
Hexagon wrench set (Metric)
Open/ box end wrench set (7 - 19mm)
Phillips screwdriver
See Spare Parts Order Section for a list
of optional and recommended spare parts.
Sections
1 13.4
1 13.5
2 13.6
2 13.7
2 13.7-13.8
2 See Manual 2 or 3
2 13.10
Qualification 2
Should tape adhesive build-up
occur, carefully wipe clean with
oily cloth or brush. Oil prevents
the build-up of tape adhesive.
(See Manual 2 or 3)
WARNING
International - ENG
February 2021