Taping Heads Completion; Outboard Tape Roll Holder; Preliminary Electric Inspection; Main Power Machine Connection And Inspection - 3M -Matic 7000a Pro Instructions And Parts List

7. Installation
7.7 Completion of Taping Heads
See Manual 2 or 3 for Complete
Instructions:
1. Place the Upper Taping Head in
2. Use Figure 7-8 and tape threading
3. Attach the threading needle to
4. Continue pulling the threading
5. Pull the threading needle down
6. Cut away any excess tape and re-
Important – Do not cut against the

7.8 Outboard Tape Roll Holder

If you intend to use the outboard
tape roll holder, proceed as follows:
1. Remove the lower taping head
2. Remove the tape drum bracket
3. Install alternative wrap roller and
4. Install and secure tape drum
3M-Matic ™ 7000a-7000a3 Pro
Page 21
(continued)
a convenient working position
label. Position the tape supply roll
so the adhesive side of tape is
facing the front of the taping head
as it is pulled from the supply roll.
the end of the roll. Guide the
threading needle around the
wrap roller (Position 1) then
back around the one-way tension
roller (Position 2).
needle down and guide it
between the two (2) rollers on
the apply arm (Position 3).
until the tape travels between the
apply plate and the ears of the
apply arm (Position 4) until it
extends past the applying roller.
When properly threaded the
adhesive side of the tape should
be facing the knurled rollers at
position 2 and also position 3.
peat steps for Lower Taping Head.
apply roller - roller
damage could occur.
from the machine.
assembly, stud spacer, and fast-
eners from the lower taping head.
bracket on the head in place of
tape bracket. Replace lower
head into machine.
bracket assembly on the entry
end of the lower frame
(as shown in Figure 7-9).
#2
#3
Figure 7-8
Figure 7-9
7.9

Preliminary Electric Inspection

Before connecting the machine to
the mains please carry out the
following operations:
7.9.1 Make sure that the socket is pro-
vided with an earth protection
circuit and that both the mains
voltage and the frequency match
the speci cations on the name plate.
7.9.2 Check that the connection of the
machine to the mains meets the
safety regulations in your country.
7.9.3 The machine is tted with a main
switch and a circuit breaker.
The user should check that the
electrical settings of the machine
are compatible with all the
components of the mains system.
7.10 Machine Connection to the Mains
For technical speci cations:
See Section 4 - Speci cations
- Push the LATCHING EMERGENCY
STOP BUTTON.
- The main switch turned OFF (O).
Connect the power cord supplied with the
machine to a wall socket using a plug which
complies with the safety regulations of your country.
One Way
Tension
Roller
#1
Tension
Wrap
Roller
Knurled
Roller
Wrap
Roller
Applying
Roller
Threading
#4 Needle
NA - ENG
March 2017