Taping Heads - 3M -MATIC 8000a-T Instructions Manual

13-MAINTENANCE AND REPAIRS (continued)
13.11.2 Taping Heads (Refer to Figure 13-5A, 13-5B, and 13-5C)
Taping Head Adjustments
To reduce the risk associated with sharp blade hazards:
•
− Keep hands and fi ngers away from tape cutoff blades under orange blade guards.
The blades are extremely sharp
Tape Web Alignment – Manual 2
Tape Drum Friction Brake – Manual 2
Applying Mechanism Spring – Manual 2
One Way Tension Roller – Manual 2
Tape Leg Length
Leading Tape Leg Length Adjustment – Manual 2
Changing Tape Leg Length from 70 to 48mm [2-3/4 to 2 inches] – Manual 2
Note – Changing tape leg to 48mm [2 inches] requires machine adjustment also. See Manual 2 or 3
"Special Set-Up Procedure – Changing Tape Leg Length".
1. Loosen, but do not remove, the two (2) retaining screws that secure the upper taping head shown - Figure 13-5A.
2. Hold upper taping head applying and buffi ng arms from under upper assembly, slide head forward and down to
remove Figure 13-5B.
3. Lift the lower taping head, shown in Figure 13-5C, straight up to remove it from the case sealer bed.
4. Refer to Manual 2 (Taping Head), See "Adjustments – Changing Tape Leg Length" for taping head set-up.
Figure 13-5 Removing Taping Heads From Case Sealer
8000a-8000a3 - NA
WARNING
B
C
33
A
2014 June