Instruction book
For the design of piping and supporting structures, use an approved standard code (e.g. EN
13480 or ASME 16.5/B31.3).
While installing the compensator, please mind the following check points to avoid sealing
damage.
AIF999999
The compensator loads (F
• Weight loads F
g
• Thrust forces F
t
Mind that the connected pipe at customer side does not create any flow restriction
caused by e.g. section reduction.
and F
) that are mentioned on the drawing are strictly forbidden:
g
t
57
Need help?
Do you have a question about the ZR 200 and is the answer not in the manual?