Canon imageCLASS D600s Service Manual page 314

##104 [TX]
Cause:
Remedy:
Cause:
Remedy:
##106 [RX]
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
COPYRIGHT © 2001 CANON INC.
Chapter7C.p65
RTN or PIN has been received
The line condition is poor so that the other party cannot receive the image signal
correctly.
1. Increase the transmission level so that the other party may receive the image
signal correctly.
2. Decrease the transmission start speed.
3. Adjust the NL equalizer so that the other party may receive the image signal
correctly.
4. Add an echo protect tone to the V.29 modem signal for transmission.
5. Ask the operator of the other party to loosen the RTN transmission conditions
so that the other party will not transmit RTN.
The machine malfunctioned because of an echo.
1. Using a manual call, press the Start button after hearing the 1st DIS from the
other party.
2. To prevent response to the 1st DIS from the other party, put a relatively long
pause to the telephone number when registering an auto-dialing number.
3. Ask the operator of the other party to provide echo remedy 1.
4. Ask the operator of the other party to decrease the transmission level so that the
other party will not receive an echo.
The procedure signal cannot be received for 6 sec while in wait
The line condition is poor, and the procedure signal from the other party cannot be
received correctly.
1. Ask the operator of the other party to increase the transmission level so that the
procedure signal may be received correctly.
2. Adjust the NL equalizer so that the procedure signal may be received correctly.
The line condition is poor, and the other party cannot receive the signal.
1. Increase the transmission level so that the other party may receive the signal
correctly.
2. Adjust the NL equalizer so that the other party may receive the signal correctly.
The machine malfunctioned because of an echo.
1. Provide echo remedy 1.
2. Decrease the transmission level so that an echo of transmitted signal will not be
received.
CANON imageCLASS D600s/PC1060s/PC1200s/iR1200s REV. 0 SEPT. 2001
59
CHAPTER 7 TROUBLESHOOTING
8/26/01, 3:49 PM
7-59