Table of Contents
Advertisement
3.19
Test Mode (TEST MODE)
3.19.1 Outline
When using test mode, be sure to execute items according to the menu indicated on the
display. The menu items in test mode are grouped into 7 blocks.
1. D-RAM Test (1: DRAM)
Use it to be sure that data is properly written to and read from the D-RAM.
2. CCD Test (2: CCD TEST)
Use it to correct any variation in sensitivity among the light-receiving cells of the CCD.
3. PRINT Test (3: PRINT)
Use it to print 8 types of patterns within the print area in Fine mode.
4. MODEM NCU Test (4: MODEM NCU)
Use it to execute a relay operation test or modem DTMF and total signal transmission/
reception tests.
5. AGING Test (5: AGING TEST)
Use it to turn on the scanning lamp and drive the original feed motor in Fine mode. The
printer will print a pattern of slant band in normal print density continuously.
6. FACULTY Test (6: FACULTY TEST)
Use it to check the operation of microswitches, sensors, speakers, and ADF.
7. BOOK Test (8: BOOK TEST)
Use it to operate the machine suited to a specific level of read transmission image quality.
COPYRIGHT © 2001 CANON INC.
Chapter2.p65
CANON imageCLASS D600s/PC1060s/PC1200s/iR1200s REV. 0 SEPT. 2001
55
CHAPTER 2 USING THE MACHINE
8/26/01, 3:42 PM
2-55
Advertisement
Table of Contents
Troubleshooting
