Others; Fan; Outline - Canon imageCLASS D600s Service Manual

8 Others

8.1

Fan

8.1.1

Outline

The machine is equipped with a single fan at the rear of the delivery assembly to cool the
laser unit, to discharge heat from around the fixing assembly, to cool the elements of the
PCBs, and to discharge ozone.
The fan is controlled by the CPU on the DC controller PCB for the following:
• full-speed rotation while the main motor is in operation.
• full-speed rotation for 30 sec and half-speed rotation for 60 sec after the main motor
stops.
• full-speed rotation for 30 sec and half-speed rotation for 60 sec during WAIT.
The CPU on the DC controller PCB generates the fan drive signal (FANON) based on the
state of the fan stop signal (FANSTOP; 0: reset, 1: rotate) and the full-speed/half-speed
switch signal (FANHALF; 0: half-speed, 1: full-speed) to control the fan rotation to any of
three: rest, half-speed, full-speed.
• Power supply PCB
• DC controller PCB
COPYRIGHT © 2001 CANON INC.
Chapter4.p65
Fixing assembly
F04-801-01
CANON imageCLASS D600s/PC1060s/PC1200s/iR1200s REV. 0 SEPT. 2001
33
CHAPTER 4 OPERATION
Main motor
Laser scanner unit
Cartridge
8/26/01, 3:44 PM
4-33