When Using The Framestart Trigger - IAI GOX-5105M-5GE User Manual

Tentative version

Table of Contents

Notes:

The settings for exposure control and triggers are related to each other. Be sure to configure

the settings described in

You can delay when exposure actually starts after a trigger is received for a specific amount

of time by configuring TriggerDelay.

Select the trigger type with TriggerSelector, and set the following items for each trigger.

TriggerMode

Switch enable or disable.

Select the source signal (PulseGenerator0-3, UserOutput0-3, Action0-3, Software, Line5

Opt In, Nand0 Out, Nand1 Out).

TriggerSource

TriggerActivation Sets the polarity of the trigger signal.

You can specify a delay after receiving the trigger signal until the trigger is enabled.

TriggerDelay

When Using the FrameStart Trigger

When AcquisitionStart is executed and a FrameStart trigger is received before the AcquisitionStop

command is executed, one frame is acquired.

The source signals that can be set for the AcquisitionStart, AcquisitionEnd, FrameStart, and

AcquisitionTransferStart triggers are as follows:

Software, PulseGenerator 0 – 3, UserOutput 0 – 3, Action 0 – 3, Line5 Opt In 1, NAND0 Out, and

NAND1 Out.

Exposure

Note: Trigger can be executed by TriggerSoftware[TriggerSelector] command only

when Software is set.

Note: This trigger type is available only when TriggerSelector is set to FrameStart.

User Manual (Ver. Tentative) - Main Functions

Mode.

- 40 -

Table of Contents