Characteristics Of The Recommended Circuits For Opto Out - IAI GOX-5105M-5GE User Manual

Tentative version

Table of Contents

Characteristics of the Recommended Circuits for Opto OUT

OUTPUT LINE RESPONSE TIME

For the operating conditions of applied voltage (User Power) +12V, load resistance 10kΩ, and cable

length 1m, the timing is shown in the table below.

TDR (Time Delay Rise)

RT (Rise Time)

TDF (Time Delay Fall)

FT (Fall Time)

Note: Since it varies depending on the applied voltage, load resistance, cable length, etc., check

the actual environment before use.

Cautions:

Please note that the recommended load resistance of Opto output is 10 kΩ (rated 1/10 W) or

more. The 270 Ω resistor shown in the circuit diagram is the MINIMUM resistance that should be

used. The response speed from On (High) to Off (Low) depends on the voltage applied to Opto

output and the value of the load resistance. Higher load resistance results in a slower response. If

the response at 10 kΩ is slower than desired, you can try reducing the load resistance in order to

increase the response speed but DO NOT go below the minimum 270 Ω value.

The load resistance loss can be calculated as follows.

load resistance loss ≒ (voltage applied to Opto output )

Item

- 19 -

User Manual (Ver. Tentative) - Parts Identification

0.48 (μs)

3.08 (μs)

3.16 (μs)

52.4 (μs)

/ (load resistance)

Result (Typ)

Table of Contents