Oki PRO330S User Manual page 93

• Handling the last sheet of continuous paper
When using continuous paper such as roll paper or fanfold paper, follow the procedure
below if the remaining paper length of the continuous paper does not match the length of
paper to be printed.
• When the remaining paper is not long enough to print the data
Remaining paper length
Printed paper length
• When the remaining paper is long enough to print the data
Remaining paper length
Printed paper length
• When the remaining paper is longer than the print data (When the rear edge of the paper
exceeds the paper detection sensor in the paper insertion slot during operation)
Remaining paper length
Printed paper length
Printed paper length
• Exception (when approx. 82 mm or less of paper is left after printing)
Remaining paper length
Printed paper length
The print data cannot be printed.
A "PAPER SIZE ERROR" may occur after printing is completed.
If an error occurs, open and close the top cover to clear the
error. "RESTART PRINT?/OK OR FEED/CUT" will appear on the
display. Load new paper, and press «OK» to resume printing
from the page where the error occurred.
However, if [MENUS] - [JAM RECOVERY] is set to [OFF], the
RESTART PRINT message will not appear and the page where
the error occurred cannot be printed again.
The print data will be printed normally, and the process will
exit.
The print data will be printed normally, and the process will
exit.
Cut the remaining paper and eject it to the rear. When
the next print data is received in that state, "490:FEEDER
EMPTY" appears on the display. Remove the last paper that
was ejected and load new paper.
Cut position
If the remaining cut paper is approximately 82 mm or less,
eject the printed paper together with the paper that is not
cut so that no paper is left in the machine. In this case, the
paper to be ejected will be "Length of the printed page +
Remaining paper (approx. 82 mm at maximum)".
- 93 -