Oki PRO330S User Manual page 194

Possible causes
Network connection settings
are incorrect.
[Wireless (Infrastructure)]
Not connected to a wireless
LAN access point.
Solution
• [WIRELESS
(INFRASTRUCTURE)] and
[WIRELESS(AP MODE)]
cannot be enabled at the
same time.
• To connect using [WIRELESS
(INFRASTRUCTURE)],
set [WIRELESS(AP
MODE)] to [DISABLE]
and then set [WIRELESS
(INFRASTRUCTURE)] to
[ENABLE].
• To connect using
[WIRELESS(AP MODE)],
set [WIRELESS
(INFRASTRUCTURE)] to
[DISABLE] and then set
[WIRELESS(AP MODE)] to
[ENABLE].
• Check that the power switch of
the wireless LAN access point
is turned on.
• Check settings of the wireless
LAN access point, and then
perform manual setup or
automatic setup.
• Restart the wireless LAN
function.
• Go to [ADMIN SETUP]
- [NETWORK SETUP]
- [ENABLING DEFAULT
GATEWAY] - [WIRELESS
(INFRASTRUCTURE)], and
select [RECONNECTION].
• Put this machine in an
unobstructed view position
near the wireless LAN access
point. (The recommended
distance is 30 m or less)
Do not place an electric
appliance (especially
microwave oven or digital
cordless telephone) that emits
weak electronic waves near
this machine.
It may be difficult to connect
if there is a metal, aluminum
sash or reinforced concrete
wall between this machine and
the wireless LAN access point.
- 194 -
Reference
Connecting via a wireless
LAN
Connecting via a wireless
LAN