Oki PRO330S User Manual page 246

• Setting with PEAP
This section describes how to set up PEAP, one of the IEEE802.1X authentication.
1
Open the web page of this machine.
• For details on how to open it, refer to
2
Log in as an administrator.
3
Select [Admin Setup].
4
Select [Network] - [IEEE802.1X].
5
Select [Enable] in [IEEE802.1X].
6
Select [PEAP] in [EAP Type].
7
Input the user name in [EAP User].
8
Input the password in [EAP Password].
9
Select [Authenticate Server], and click [Import].
10
Input the file name of the CA certificate, and click [OK].
Specify the CA certificate used for RADIUS server authentication. PEM, DER and KCS#7
files can be imported.
11
Click [Submit].
The new settings will take effect after the network function of the machine has been reset.
12
When the machine is ready to print, power off the machine.
• Refer to "Turning the power off" (Page 35)
13
Remove the LAN cable from the machine.
14
Proceed to "Connecting this machine to the authentication switch".
• Connecting this machine to the authentication switch
1
Check that this machine is powered off.
2
Connect the LAN cable to the network interface connector of this machine.
3
Connect the other end of the LAN cable to the authentication port of the
authentication switch.
4
Power on this machine.
• For details on how to turn on the power, refer to
5
Set the IP address of this machine.
"Opening the web page" (Page
for details on how to turn the power off.
"Turning the power on" (Page
- 246 -
225).
34).