Oki PRO330S User Manual page 189

Message
PLEASE DETACH IT
USB HUB UNSUPPORTED
PLEASE DETACH IT
UNSUPPORTED USB DEVICE
DETECTED
PLEASE DETACH IT
UNRECOGNIZED USB DEVICE
□
SNTP SERVER COMMUNICATION
ERROR
□
FILE OPERATION FAILED [FS_ERR]
PRESS OK BUTTON
INVALID DATA
CHANGE IPv4 ADDRESS
IPv4 ADDRESS IS CONFLICTED
PAPER DETECTION ERROR
[ERRCODE]:ERROR [SUBCODE]
CHANGE [MEDIA_SIZE] [MEDIA_TYPE]
PRESS OK BUTTON
RESTART PRINT?
OK OR FEED/CUT
REDUCE PRINT DATA
[ERRCODE]: MEMORY OVERFLOW
PRESS OK BUTTON
[ERRCODE]: WIRELESS STARTUP
ERROR
PRESS OK BUTTON
[ERRCODE]: WIRELESS SETTINGS
ARE INCOMPLETE
PRESS OK BUTTON
[ERRCODE]: NOT CONNECTED TO
WIRELESS ACCESS POINT
NETWORK CONFIG
WRITING
A USB hub which is not applicable to this machine is
connected. Please detach the hub.
A USB device which is not supported by this machine is
connected. Please detach the USB device.
The USB device connected to the machine was not
recognized correctly. Please detach the USB device.
Failed to retrieve the time from the SNTP server.
Check the network settings.
An error has occurred in the file system of the machine.
Operation without the file system is possible.
The error disappears when the next print data is
received.
Invalid print data was received.
Press «OK» to clear the error.
The IPv4 address conflicts with that of another
machine.
Check the IPv4 address.
The paper sensor cannot detect paper correctly.
Check the position, dirt, and settings of the paper
sensor.
The meaning of [SUBCODE] is as follows.
0-6: An error has occurred to the lower sensor.
11-15: An error has occurred to this upper sensor.
21-26: An error has occurred to the transmission
sensor.
The type of the paper loaded in the machine does not
match the print data. Remove and load the paper again
correctly. Once you have loaded the paper, press «OK».
Press «OK» to resume the printing immediately.
Press «FEED/CUT» to cut the paper at the specified
position and resume the printing.
Press «CANCEL» to return to the standby screen
without printing.
The print data is too complicated. Reduce the amount
of print data.
This error will be cleared automatically after
approximately 15 seconds.
The wireless LAN module is not correctly connected to
the machine.
Connect the wireless LAN module to the machine
correctly, and turn the power of the machine off and
then turn it back on.
Press «OK» to hide this message.
The wireless LAN settings are incomplete
Press «OK» to hide this message.
The wireless access point is not connected.
Press «OK» to hide this message.
Network-related items are being set.
- 189 -
Description