Possible causes
This machine is warming up
for recovering from the Power
Save or Sleep mode.
Cleaning of image drum may
be in progress.
Temperature adjustment of
the fuser unit is in progress.
Processing of data from other
interface is in progress.
The print data is not sent
Possible causes
The LAN/USB cable is broken. Connect with a new cable.
The PC has timed out.
An abnormal sound is heard
Possible causes
This machine is tilted.
Paper dust or foreign objects
are left inside this machine.
A resonant sound is heard
Possible causes
While the temperature
inside this machine is rising,
printing is done on thick
paper.
Solution
Sets the time that will elapse
before the machine enters the
Power Save or Sleep mode.
From the operator panel, go to
[MENUS] - [SYSTEM ADJUST] -
[POW SAVE TIME] or [SLEEP
TIME], and set an appropriate
time.
Please wait for a while.
Please wait for a while.
Wait until the processing is
complete.
Solution
Increase the length of timeout.
Solution
Install it on a stable and flat
surface.
Check the inside of this machine
and remove the object if any.
Solution
This is not a fault with this
machine. Use it as it is.
- 209 -
Reference
Setting the time that
elapses before entering
the power save mode
Setting the time that
elapses before entering
the sleep mode
-
-
-
Reference
-
-
Reference
-
-
Reference
-