Oki PRO330S User Manual page 190

Message
WAIT A MOMENT
NETWORK INITIAL
DOWNLOAD MESSAGE
PROCESSING
DOWNLOAD MESSAGE
WRITING
DOWNLOAD MESSAGE
SUCCESS
DOWNLOAD MESSAGE
FAILED [ERRCODE]
PRESS OK BUTTON FOR RESTORATION
[ERRCODE]: RECEIVING DATA
TIMEOUT
PLEASE TRY AGAIN
[ERRCODE]: FW UPDATE ERROR.
IF NETWORK DOESN'T WORK,
PLEASE TRY FW UPDATE OVER USB
LOAD [MEDIA_SIZE]
490: FEEDER EMPTY
REPLACE TONER
412: TONER EMPTY
TONER NOT RECOMMENDED
[ERRCODE]:ERROR
INSTALL TONER
612: TONER MISSING
IMAGE DRUM NOT RECOMMENDED
[ERRCODE]: ERROR
UNKNOWN CONSUMABLE
GO TO USER MANUAL "TROUBLE
SHOOTING"
OPEN TOP COVER
[ERRCODE]: PAPER SIZE ERROR
Network-related items are being initialized.
The message data to be updated is being processed.
The message data to be updated is being written.
Writing the message data to be updated was
successful. Then, the machine will restart.
Failed to write the message data to be updated.
A timeout occurred while receiving data.
This error will be cleared automatically after
approximately 15 seconds.
Failed to update the firmware.
Please update the firmware again.
The paper runs out. Please load paper in the machine.
The toner runs out. Replace the toner cartridge with a
new one.
Replace the toner cartridge with an appropriate one.
ERRCODE: 552, 556, 616, 622
No toner cartridge is installed in the machine. Install
the toner cartridge into the machine.
Replace the image drum with an appropriate one.
ERRCODE: 686, 692, 702, 706
You can use any consumables in your product, but
you must accept the risks of using non-genuine
consumables.
If the use of non-genuine consumables causes damage
to the product or results in your product not functioning
to its full specification, then such damage or effect on
the product is not covered by warranty.
When you understand the above points and use non-
genuine consumables, follow the procedure below.
(1) Power off the machine
(2) Turn the power on while pressing «CANCEL»
(3) Release «CANCEL» upon startup
The above operation will be recorded inside this
machine.
Should you have any question, please contact your
dealer.
The paper of an incorrect size was fed. Check that the
size of paper loaded in the machine is correct and the
paper is not multi-fed. Then, open and close the top
cover.
- 190 -
Description