Install Pcmcia Cards; Install The 2.4Ghz Pcmcia Radio; Figure 2-37 Inserting The 2.4Ghz Type Ii Pcmcia Radio - LXE VX5 Reference Manual

50

Install PCMCIA Cards

Equipment Needed: Phillips No. 1 screwdriver and a Torque wrench capable of measuring to 9±1
inch pounds (1.016±.11 N/m).
Note:

Install the 2.4GHz PCMCIA Radio

Caution
1. Turn the VX5 off and detach the power cable.
2. Loosen the three (3) Phillips head screws securing the access panel cover so the cover can
be removed. The screws are a captive part of the cover and cannot be removed.
Partially insert the 2.4GHz Type II PCMCIA Radio into Slot 0 (the upper right slot).
Caution
Note:
VX5 Reference Guide
The example below details installing a 2.4GHz radio card.
PCMCIA cards is similar, except there is no antenna.
The LXE Model VX5 Vehicle Mount Computer is specifically for use with
LXE Model Numbers 4830, 6726 and 6816 2.4GHz Type II PCMCIA radios.
Substitution of other PCMCIA radios will void the FCC, Industry Canada
!
and other international radio certifications for the Model VX5 Vehicle Mount
Computer and is strictly prohibited.
Slot 0 MUST BE used for the radio card. Installing a radio card in Slot 1 can
result in pinching or other damage to the internal antenna cable.
!

Figure 2-37 Inserting the 2.4GHz Type II PCMCIA Radio

The tethered access panel cover is not shown in the illustration above.
PCMCIA/CardBus and ATA Slots
COM1 COM2
IDE DRIVE
SCANNER CARD BUS A
SERIAL CARD BUS B
USB
PCMCIA/CF ATA
Radio Card
Installation of other
E-EQ-VX5RG-G