Figure 4-9 Sign-On Screen - LXE VX5 Reference Manual

Summit Radio
How to: Use Sign On Screen
1. After completing the other entries in the profile, click on the Credentials button. Leave the
Username and Password blank. No entries are necessary on the Credentials screen for LEAP,
WPA/LEAP or EAP-FAST using automatic PAC provisioning.
2. Make sure the Validate server checkbox is checked fro PEAP-MSCHAP and PEAP-GTC.
3. Make sure the certificate or manually created PAC has been copied to the directory specified
in the Certs Path global variable.
4. For EAP-FAST with manual PAC provisioning, enter the PAC Filename and Password.
5. For PEAP-MSCHAP and PEAP-GTC enter the CA certificate filename.
6. Click the OK button then the Commit button.
7. When the device attempts to connect to the network, a sign-on screen is displayed.
8. Enter the Username and Password. Click the OK button.
9. Verify the device is authenticated by reviewing the Status tab. When the device is property
configured, the Status tab indicates the device is Authenticated and the method used.
10. The sign-on screen is displayed after a reboot for each of the listed protocols.
Note:
E-EQ-VX5RG-G

Figure 4-9 Sign-On Screen

Complete details are provided in the appropriate Summit Wireless Security section
following in this chapter.
If a user enters invalid credentials and clicks OK, the device associates but does not
authenticate. The user is again prompted to enter credentials.
If the user clicks the Cancel button, the device does not associate. The user is not
prompted again for credentials until the device is rebooted, the radio is disabled then
enabled, the Reconnect button on the Diags tag is clicked or the profile is modified and
the Commit button is clicked.
131
VX5 Reference Guide