Table of Contents
Advertisement
Figure 3.
2.2.5
Auto-Iris Lens Setup
Auto-iris lenses with full video input can be used with the JAI, Inc. RM-67X.
Note: Make sure that the power is removed from the camera before connecting or disconnecting the auto-iris
lens. There is a small chance that damage could occur to the auto-iris lens by plugging or unplugging it
while the camera is powered up.
Power down the camera before installing the auto-iris lens. To install the auto-iris lens in a JAI, Inc. camera, wire the
signal on the lens to the 1 V peak-to-peak video output (pin 11) on the camera.
Point the camera at a light area and then quickly towards a darker area. If everything is working properly, the iris should
adjust for the light change.
2.2.6
Monitor Display Mode
For monitoring real time video, connect the video output to a video monitor or other device.
2.2.7
Connectors and Cables
15-pin connector and cable: Standard cable is 15P-02-9P and 15P-02-9P-FULL.
Figure 4.
16
RM-67X Series
Back Focus Set-Screw Locations
15P-02-9P Cable
Hardware Installation
Advertisement
Table of Contents
