Table of Contents
Advertisement
8 CONTROLLER PARAMETER SETTINGS
a.
Under standby status, press
screen (Fig. 4). At this moment the first digital flashes.
b.
Press
correct setting, press
c.
After the password is passed it will enter parameter setting screen (Fig. 5). At this moment it
displays the serial number of the setting item and the set value. Press
item goes down; Press
d.
Press
time the first digital number is flashing and the setting method is same as Step a.
MGC300 Series Genset Controller User Manual
Fig. 4 Password Entry Screen
and the flashing number adds 1; Press
/
and the setting item goes up.
Fig. 5 Parameter Setting Screen
/
and it enters the setting status of the current parameter value. At this
at the same time, it will enter password entry
to move.
and it decreases 1. After
and the setting
Page 21 of 26
Advertisement
Table of Contents
