Loading Port Configuration - Comtrol DeviceMaster LT User Manual

Loading Port Configuration

Loading Port
Configuration
82 - Managing the DeviceMaster LT
6. Highlight the configuration file and click Open. The configuration file loads in
a few moments.
7. Make the appropriate choice for your situation:
• Click No to the ComtrolApplet message, if you are using the file to set up
multiple DeviceMaster LTs with the same device-level settings.
• Click Yes to the ComtrolApplet message, if you are using the file to restore
a specific DeviceMaster LT. For example, you needed to remove and then
re-install the DeviceMaster LT NS-Link device driver.
8. Click Apply so that the configuration is saved on the DeviceMaster LT.
9. Go to the next procedure if you want to restore port settings from a
configuration file.
Use the following procedure to load the configuration file for port-level settings for
your DeviceMaster LT.
Note: Device driver configuration files must be for the same model with the same
port density
1. If necessary, open the Comtrol Drivers Management Console using one of these
methods:
• Windows Control Panel; go to your Control Panel and click on the
Comtrol Drivers Management Console.
• Shortcut; located under Start> Program Files> Comtrol> DeviceMaster LT>
Comtrol Drivers Management Console.
2. Depending on your operating system, you may need to click Yes to the Do you
want to allow the following program to make changes to this computer? User
Account Control message.
DeviceMaster LT User Guide: 2000586 Rev. B