Configuring Passwords - Comtrol DeviceMaster LT User Manual

Configuring Passwords

Configuring Passwords
106 - RedBoot Procedures
If uploading SocketServer:
a. At the RedBoot> prompt, type: fis list and press Enter.
RedBoot> fis list
Name
FIS_directory
default
RedBoot>
Note: You should see file information for a file called default. If you do not
see this file, repeat the process starting with
b. Reset the DeviceMaster LT by typing reset at the RedBoot> prompt.
Note: In a few seconds the ethernet and Status LED cycle through a light
sequence once.
c. Start your internet browser and enter the IP address of the DeviceMaster
LT to verify that the new version of SocketServer loads.
This section discusses how to configure a password for the web and telnet server.
Note: See the PortVision DX or SocketServer Help system for information about
email notification.
Use the following procedure to establish the DeviceMaster LT password for the
Web and telnet server. Establishing a password prevents unauthorized changes to
the DeviceMaster LT configuration.
1. Establish communications with the DeviceMaster LT using the serial (Page
100) or telnet method (Page 101).
2. Type password [your_password] and press Enter.
Note: If you forget your password, you can reprogram the password using the
serial method which bypasses the password.
Password:
*********************************************
**
** Comtrol DeviceMaster Bootloader Version 3.23
** RedBoot(tm) environment - built 14:59:20, Oct 13 2011
** Platform: Comtrol DeviceMaster (ARM 7TDMI)
** Portions Copyright (C) 2000. Red Hat, Inc.
** Portions Copyright (C) 2001-2008 Comtrol Corp.
*********************************************
FLASH: 64 blocks of 65536 bytes each
FLASH: 4194304 bytes (0x05000000 - 0x05400000)
RAM: 8126464 bytes (0x00000000 - 0x007c0000)
RedBoot> dis
Loading disabled
RedBoot> password dev1357
Password 'dev1357'
RedBoot
>
Note: The Bootloader version on your DeviceMaster LT may be different than
the version displayed in this graphic.
See the auth command in the
want to set up Web browser authentication.
FLASH addr Mem addr
0x053F0000 0x053F0000
0x05030000 0x00000000
RedBoot Command Overview
DeviceMaster LT User Guide: 2000586 Rev. B
Length Entry point
0x00010000 0x00000000
0x00090000 0x00000000
Step 9.
on Page 107, if you