Comtrol DeviceMaster LT User Manual page 10

Locating Software and Documentation
10 - Introduction
If you are not sure what files are required for your installation, each
Overview subsection also provides links to the required files in this Guide.
Software
PortVision DX
SocketServer
Linux
Windows 8
Windows Server 2012
Windows 7
Windows Server 2008
Windows Vista
Windows Server 2003
Windows XP
Bootloader
Any
Description/Documentation
Install on a Windows host to configure
the IP address and upload SocketServer
on the DeviceMaster LT.
This is the firmware that comes pre-
installed on your DeviceMaster LT
platform.
You may need to upload the latest
version of SocketServer before installing
and configuring drivers or configuring
sockets.
Note: May sure that you download
SocketServer for the DeviceMaster
LT (link at right). Other
DeviceMaster models use a unique
version of SocketServer.
Install if you want tty ports. Refer to the
Readme file compressed in the Linux
driver assembly for driver configuration
procedures.
Install if you want COM ports.
Refer to the DeviceMaster Device Driver
(NS-Link) User Guide. for detailed
information.
The operating system that runs on the
DeviceMaster LT hardware during the
power on phase, which then loads
SocketServer.
Only update the Bootloader on your
DeviceMaster LT if advised by Technical
Support or the ftp site when checking for
the latest SocketServer or device driver
version.
Note: May sure that you download
Bootloader for the DeviceMaster
LT (link at right). Other
DeviceMaster models use a unique
version of Bootloader.
You can check for the latest version of
this Guide.
DeviceMaster LT User Guide: 2000586 Rev. B
Installation
File