1-Port Installation - Comtrol DeviceMaster Up Hardware Installation Manual

1-Port Installation

1-Port Installation
Caution
10 - DeviceMaster UP User Guide: 2000451 Rev. C
Use the following procedure to install the DeviceMaster UP 1-Port.
1. Record the MAC address, model number, and serial number of the
DeviceMaster UP unit on the customer service label provided.
The serial number and MAC address are located on a label on the device. The
MAC address starts with 00 C0 4E.
2. Place the DeviceMaster UP 1-Port on a stable surface and skip to
optionally mount the DeviceMaster UP using the mounting flanges or DIN rail
adapters.
a. Pick up the DeviceMaster UP so that the front of the device is facing you.
b. Pick up a DIN rail clip. (The three tines should be on top
and the M4 label should face you.)
c. Slide the DIN rail clip behind the DeviceMaster UP and
line it up with one of the screw holes on the
DeviceMaster UP.
d. Insert a screw into the hole and tighten with a Phillips
screwdriver.
e. Repeat Steps b
rail clip. Make sure the screws on both DIN rail
clips line up.
Note: If you need to remove the DeviceMaster UP
from the DIN rail, exert pressure on the
backside of the tabs at the bottom of both
DIN rail clips.
f. Attach the DeviceMaster UP to the DIN rail.
Note: For optimal
operation, make
sure that the
device is mounted
in a vertical
orientation with a
minimum of 1.0"
space on either
side and a
minimum of 4.5"
clearance from the
center of the rail to
any device or wire trough above the unit and a minimum of 5.0" below.
3. Connect the DeviceMaster UP port labeled 10/100 ETHERNET to the same
Ethernet network segment as the PLC using a standard network cable.
The default serial port setting on the DeviceMaster UP is RS-232. Do
not connect serial devices until you have configured the serial port
settings. You must first configure the network and then upload the
firmware before you can configure serial port settings.
4. Apply power to the DeviceMaster UP using the following procedure.
Note: See Power Supply for the 1-Port
own power supply.
through d with the second DIN
1.0"
4.5"
5.0"
on Page 32, if you want to provide your
M4
Side View
Press here
1.0"
DeviceMaster UP
Front View
Hardware Installation
Step 3 or
DIN Rail
Clip