Rts 1-Port Installation - Comtrol DEVICE MASTER RTS Hardware Installation And Configuration

RTS 1-Port Installation

Caution
Hardware Installation
Use the following procedure to install the RTS 1-Port.
1. Record the MAC address, model number, and serial number of the
DeviceMaster RTS unit on the customer service label provided.
You may need the MAC address during driver configuration. The serial
number and MAC address are located on a label on the device. The MAC
address starts with 00 CO 4E.
2. Place the DeviceMaster RTS 1-Port on a stable surface or optionally mount the
RTS using the DIN rail adapters or mounting flanges.
3. Connect the RTS port labeled 10/100 ETHERNET to the same Ethernet
network segment as the host PC using a standard network cable.
If you plan on using the NS-Link device driver, make sure that you do
not connect RS-422/485 devices until the appropriate port interface
type has been configured in the driver. The NS-Link default port
setting is RS-232.
4. Apply power to the RTS by connecting the AC power adapter to the RTS and a
power source. If you want to provide your own power supply, see
Specifications on Page 19.
5. Verify that the network connection for the RTS is
functioning properly.
• The amber Status LED on the device is lit,
indicating you have power and it has completed the
boot cycle.
Note: The Status LED flashes while booting and it
takes approximately 15 seconds for the
bootloader to complete the cycle.
• If the red Link Act LED is lit, it indicates a working
Ethernet connection.
• If the red Duplex LED is lit, it indicates full-duplex
activity.
• If the red 100 LED is lit, it indicates a working 100 MB Ethernet connection
(100 MB network, only).
6. Go to Configuring the Network Setup
and how to configure the RTS for use.
RTS 1-Port Installation
Larger Picture, Page 22
on Page 12 for default network settings
Power Supply
6