Comtrol DeviceMaster LT User Manual page 108

RedBoot Command Overview
mcopy -s <location>
-d <location> -l <length>
[-1|-2|-4]
mfill -b <location> -l <length>
-p <pattern> [-1|-2|-4]
model†
password {password}
ping [-v] [-n <count>]
[-l <length>] [-t <timeout>]
[-r <rate>]
[-i <IP_addr>] -h <IP_addr>
reset
secureconf [disable|enable]
securedata [disable|enable]
?
snmp [disable|enable]
telnet [disable | enable}
teltimeout [seconds]
terse
timeout {seconds}
version
x -b <location> [-l <length>] [-s]
[-1|2|4]
† Do not use these commands to change the values. Doing so would cause the DeviceMaster LT to
stop functioning.
108 - RedBoot Procedures
RedBoot Commands (Continued)
Copies memory from one address to another.
Fills a block of memory with a pattern.
Shows model number.
Sets or deletes the password.
Network connectivity test.
Resets the DeviceMaster LT.
Sets or displays secure config enable.
Sets or displays secure data enable.
Displays short help.
Sets or displays SNMP enable.
Sets or displays telnet server enable. Disables telnet.
Shows or sets telnet time-out.
Terse command response mode.
Displays or sets Bootloader time-out value.
Displays RedBoot version information.
Displays (hex dump) a range of memory.
DeviceMaster LT User Guide: 2000586 Rev. B