Enabling Secure Data Mode - Comtrol DeviceMaster LT User Manual

Enabling Secure Data Mode

DeviceMaster LT User Guide: 2000586 Rev. B
6. Click Apply to save these changes.
Note: If you selected RS-422 mode, make sure that there is not a device
attached to the port and click Ok.
7. Highlight the next port that you want to configure and perform
through 6.
8. Refer to Connecting Serial Devices
9. Optionally, you may need to configure one or more ports for socket mode
(Socket Port Configuration
In addition to enabling SSL mode in the driver, you must Enable Secure Data Mode
in the NS-Link web page. Use the following procedure to implement the Enable
Secure Data Mode option.
1. Access the NS-Link web page using one of these methods:
• Open your web browser, enter the IP address, and press Enter.
• Right-click the DeviceMaster in the Device List pane in PortVision DX and
click Webpage.
2. Click the Security tab.
3. Click Enable Secure Data Mode and Save.
4. Configure your security key and certificate and click Set.
Click the Help button if you need information about key and certificate
management.
on Page 43 to attach your serial device.
on Page 41).
Device Driver (NS-Link) Installation - 39
Enabling Secure Data Mode
Steps 1