Adjustment Of S1 & T2 Post - Panasonic AG-DVC30P Service Manual

1-3. Adjustment of S1 & T2 Post
LISTA linearity and Envelope waveform are adjusted by S1 and T2 post. When removing the Mech. Cover (R) and
(L), which is shown in the following figure, without opening a cassette cover, it is possible to do an adjustment.
Mech. Cover (R) side: S1 Post
Mech. Cover (L) side: T2 Post
1-4. Connection of EVR Tools
To performing the confirmation of envelope (item "1-11. Self-REC/PLAY Envelope Confirmation"), the following
tools are required.
NAME
Measuring Board
EVR Connector Board
Connection Adapter
30pin Flat Cable
DC Cable
DC Cable
AC Adapter
To confirm the envelope output, connect the Connection and Measuring Boards as described below.
1. Unscrew 2 screws and remove the EVR cover.
2. Connect the 2 pcs. of 30 pin flat cables (VFK1317) between P101/P102 on the Measuring Board (VFK1308P),
and 2 connectors on the EVR Connector Board (VFK1309A). Make sure that the contact surface of 2 pcs. of 30
pin Flat Cables are inner side and direction of the EVR Connector Board is as shown in Figure. Then connect
the Connection Adapter (VFK1763).
Connect VFK1763 with VFK1309A as
shown in picture.
The unit will not work if the connector
is attached backwards.
Mech. Cover (L)
Part Number
VFK1308P
VFK1309A
VFK1763
VFK1317
VJA1128 or LSJA0310
VJA0941
-----
SCREW
VFK1763
MECH-2
Mech. Cover (R)
Pcs.
1
1 NOTE: VFK1309 also can be use
1 60 to 30pin
2
1 For Unit
1 For Measuring Board
2
EVR Cover
Part side
Connect the
VFK1763
Remark
VFK1309A
30 pin Flat Cable
VFK1308P