Panasonic AG-DVC30P Service Manual page 122

7-3. Luminance level Adjustment
1. Connect the (WFM: NTSC model / oscilloscope: PAL model) to VIDEO OUT with 75ohm termination.
2. Open the "Video adjustment menu".
3. Select "3. Luminance level adjustment" in the Video adjustment menu, and then press the "Enter" key.
4. Set to CAMERA mode in camera recorder following the message "Auto / Manually set to CAMERA mode.",
and then press the "Enter" key.
5. Adjust the arrow keys on PC so that the Y level becomes (100±2 IRE: NTSC model / 700±10 mVp-p: PAL
model).
Note: 1) Y level can be adjusted by pressing arrow keys on keyboard.
2) The waveform(figure) can be displayed by pressing F2 key.
6. When adjustment is finished, press ENTER key to white the adjusted data write to EEPROM.
7-4. Chroma level Adjustment
1. Connect the (WFM: NTSC model / oscilloscope: PAL model) to VIDEO OUT with 75ohm termination.
2. Open the "Video adjustment menu".
3. Select "4. Chroma level adjustment" in the Video adjustment menu, and then press the "Enter" key.
4. Set to CAMERA mode in camera recorder follow the message "Auto / Manually set to CAMERA mode.", and
then press the "Enter" key.
5. Adjust the arrow keys on PC so that the C level becomes (40±3: NTSC model / 300±20 mVp-p: PAL model).
Note: 1) C level can be adjusted by pressing arrow keys on keyboard.
2) The waveform(figure) can be displayed by pressing F2 key.
6. When adjustment is finished, press ENTER key to white the adjusted data to EEPROM.
NOTE:
This figure describes the NTSC model.
NOTE:
This figure describes the NTSC model.
ELE-38