Adjust Menu; Connection Of Evr Tools - Panasonic AG-DVC30P Service Manual

5-2. Adjust Menu

Setting item for VIDEO OUTPUT Level
Setting item for TEST PATTERN signal
Setting item for CAMERA Debug Information
display ON/OFF
The individual reset of the Hour Meter and AUTO OFF LOG
NOTE 1: It isn't possible to do the setting of the item of DEFFECT COMP", "TEST PATTERN", "VTR DEBUG" and
"DEBUG INF". This is for factory use only.
NOTE 2: The Adjust menu screen can not be shifted to Page 2 in the CAMERA mode.
The menu screen can be shifted to Page 2, when connecting EVR tools in the VCR mode and making
VTR_TEST SW of the measurement board set to L position.

5-2-1. Connection of EVR tools

< Required Tools >
NAME
Measuring Board
EVR Connector Board
Connection Adapter
30pin Flat Cable
Connect the EVR tools as follows.
1. Unscrew 2 screws and remove the EVR cover.
Setting item for LISTA Measurement
White Blemish Compensation
VTR Debug Information
The individual reset of the Hour Meter
Reset of AUTO OFF LOG
Part Number
VFK1308P
VFK1309A
VFK1763
VFK1317
SCREWS
(Page 1)
(Page 2)
Pcs.
1
1 NOTE: VFK1309 also can be use
1 60 to 30pin
2
EVR Cover
INF-12
ADJUST MENU
ATF GAIN ------------YES
LINEARITY ------------YES
Y LEVEL A1
C LEVEL 6B
DEFECT COMP 0
TEST PATTERN OFF
VTR DEBUG 0
DEBUG INF OFF
PRESS MENU TO EXIT
RESET MENU
THREADING RESET
TAPE RUN RESET
CYLINDER RESET
AUTO OFF LOG RESET
AUTO OFF & HOUR RESET
CAUTION !
USE FACTORY ONLY
PRESS MENU TO EXIT
Remark