Table of Contents
Advertisement
6-9. White Shading Adjustment
This adjustment is automatically executed.
1. Aim the camera recorder at white paper (use clear white paper) under the Halogen lamp condition.
2. Shoot the white paper to fully fill entire screen.
3. Set the AUTO/MANUAL SELECT switch to MANUAL position.
4. Press WHITE BAL button until mark "
5. Keep pressing WHITE BAL button "
6. Press ZEBRA button to display the marker on the screen (When press the ZEBRA button, a zebra pattern is
displayed and when pushing the ZEBRA button once again, it displays a marker at the center of the screen).
7. Press MULTI-DIAL to display the F-number.
8. Adjust the MULTI-DIAL to the luminance level to become 70 to 80% (luminance level can be confirm by
numerical value, which displayed lower left corner of screen).
9. Open the "Camera adjustment menu" in EVR software.
10. Select "10. White Shading Adjustment (Auto)" in the Camera adjustment menu, and then press the "Enter"
key.
11. Set to CAMERA mode in camera recorder follow the message "Auto / Manually set to CAMERA mode.", and
then press the "Enter" key.
10.
10.
" displayed as flash condition to execute white balance adjustment.
" display switching over to the light from the flash.
ELE-33
PRESS ENTER KEY.
PRESS ENTER KEY,
then adjustment is started.
Advertisement
Chapters
Table of Contents
